Console House 10 Mode Instruções de Operação descarregar pdf (Página 36)

Porch Lights For 2H

0=OFF 1=ON 2=DIM 3=BRT

↓

At this point, you can choose to:

- Turn the unit (Porch Light) OFF {FOR 2 HOURS}

- Turn the unit (Porch Light) ON {FOR 2 HOURS}

- DIM the unit (Porch Light) 1-9 STEPS {FOR 2 HOURS}

- BRIGHTEN the unit (Porch Light) 1-9 STEPS {FOR 2 HOURS}

A Flag is an internal setting used to conditionalize a program based on

the state of the Flag (setting), and to run macro buttons when the state

of the flag changes. Flags can be turned On, Off, and Timed On/Off.

The Omni has eight outputs that can be used to switch relays.

Outputs 1-8 are controlled as unit numbers 33-40. These are

hardwired outputs that are connected directly through the Omni and

not through a module. If you have had something connected to these

outputs, such as a sprinkler system, your dealer will explain its

operation.

Outputs cannot be brightened or dimmed.

Outputs are not affected by All On or All Off commands.

The current status (On or Off) of the auxiliary outputs can be

seen on the console.

The Omni stores names for Units, Zones, Buttons, Codes, and

Temperatures so that you don't have to remember that "UNIT 5" is the

"DEN LIGHT" and "ZONE 1" is the "FRONT DOOR". In general,

any time you enter a zone, a unit, button, code, or temperature

number, you can press the down arrow key to display its name, then

use the up and down arrow keys to scroll through the list of other

names. This is true when entering commands and programming on

the console.

Internal Flags

Direct Relay

Control

Scrolling Through

Names

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 135 136

Sem comentários

Console House 10 Mode Instruções de Operação Página 36